How to Etch Copper Infused San Mai

Step 1: Sanding

Bring your Damascus to a 400 to 600 grit finish. If you’re using muriatic acid, you can bring the Damascus up to 1200 grit, or you can leave it at 400 grit. Either is effective however the color contrast is darker with Ferric Chloride For ferric acid, keep the grit between 400 and 600.

Do not buff before etching. Buffing closes the pores in the metal, which will keep the acid from absorbing, and you’ll end up with an uneven etch.

Step 2: Washing

To etch Damascus, it should be perfectly clean. Thoroughly wash your piece, we recommend washing with dish soap and sponge and then a final wipe down with pure alcohol.

Step 3: Dilution

If you’re using ferric acid, dilute it with Distilled water to a 10% Ferric, 90% Distilled water ratio.

Never use tap water, spring water, or filtered water – they will all cause problems with the etc. Be sure that your distilled water hasn’t been sitting for more than a year. Muriatic acid needs no dilution.

Step 4: Warming the Acid

For both muriatic acid and ferric chloride, the temperature should be between 70 and 100 degrees Fahrenheit, about room temperature. If you need to warm your acid for use, the best method is to place your container of acid into a large bowl of warm water. **Never put acid in the microwave**

Step 5: Submersion Etching

Hang your Damascus piece in the etchant so it is fully submerged and hangs freely without touching the sides or bottom of the container.

After 5 minutes, gently lift the piece out of the etchant and lower it back in a few times. This helps clear away material loosened by the acid.

Then leave the piece submerged for 10 more minutes.

Step 6: Neutralization

Remove your Damascus piece from the acid and submerge it into your baking soda bath for 5 minutes to neutralize the acid. (You can also spray piece with Windex to neutralize the acid) Pat dry. After neutralizing you can spray the damascus with WD-40 and hang for 3-5 hours which can darken the color contrast, this works better with carbon steels, stainless steels won't get much darker.

 ***You can repeat steps 5 for a deeper etch if you desire***

Laisser un commentaire

Veuillez noter que les commentaires doivent être approuvés avant d'être publiés.